ActronAir LC7 Operation Manual

Also see for LC7: Installation instructions

Contents

ActronAir LC7 Operation Manual Manual pdf 10 page image

Page 10Operation Manual LC7 Wall Controller10. Adjusting Set Temperature1. Press either the “SET TEMP or ” Button to either increase or decrease the temperaturecorrespondingly.NOTE● For WARMER a room temperature, press the “SET TEMP ” Button.● For COOLER a room temperature, press the “SET TEMP ” Button.● The Set Temp is adjustable between 16°C and 30°C in 0.5°C increments.● The Set Temp is adjustable in controller even when the system is OFF.● No Set Temp displayed during Fan-Only Mode.11. Changing Operating ModeNOTEFor all modes of operation, “LOW”, “MED”, “HIGH”, “LOW CONT”, “MED CONT” and“HIGH CONT” Fan Speeds can onlybe selected if the 3-Speed Fan setting option is available. Otherwise “MED” and “MED CONT” are available for 1-SpeedFan.NOTEWhen in Fan-Only Mode “LOW CONT”, “MED CONT” and “HIGH CONT” will not be availableNOTEWhen the system is ON, the Indoor Fan can run continuously and is indicated by the “CONT” indicator on the LCD.This is generally preferred during the Cooling Mode to ensure maximum air circulation. When set to “LOW”, “MED” or“HIGH” the fan will cycle with the compressor operation according to set point and room temperatures.11.01. Fan-Only Operation1. Press the “MODE” Button until “FAN” appears on the display.NOTEThe 1-speed or 3-speed fan option will depend on the A/C model.Adjust the Indoor Fan speed (“LOW”, “MED” and “HIGH”) by pressing the “FAN” Button successivelyuntil you reach the desired speed (only for 3-speed fan).tton to change mode ofen the system is ON)ODE“ button to select the modeired. AUTO ‐ HEAT ‐ COOL ‐l disappear when outdoor unitAUTOHEATCOOLFAN