Menu
Active Controls ErgoReJoy Installation Instructions Manual
Also see for ErgoReJoy: Installation instructions
    |
ErgoReJoy™ Modular ERGOnomic REpositioning JOYstick PlatformInstallation InstructionsThe ErgoReJoy assessment kits are shipped in a custom box with each component labeledwith part numbers to facilitate installation. We recommend storing the 5” and 8” adjustablearms; double ball adaptor; and JoyPad™ with 3” extension arm in the sample case untilrequired for use during the assessment.I. Install socket brackets (30380) (with pre-installed sockets (30200)) to PWC armrestusing the Stealth universal round tube mounting brackets (refer to figure 1). If the Stealthbrackets are not compatible with the PWC armrests, please call 1-800-324-1527 ext 2946.II. Insert mini mast (30226) in socket (30200) (refer to figure 2).III. Install PWC joystick to ErgoReJoy platform (37200). Before removing joystick fromPWC, photograph a side view in its standard armrest position.A. Remove joystick harness from controller joystick port located on the PWCbase noting its location (refer to figure 3)B. Remove joystick and joystick mounting bracket from PWC.C. RNet joysticks have two different joystick cable configurations (refer to figures4 & 5).1. If the RNet joystick has a removable harness like figure 4, install theActive Controls joystick harness (30449) in place of the original harnessa. Route the 30449 cable through the long slot of the ErgoReJoyplatform (37200)2. If the RNet joystick has a fixed harness (refer to figure 5), route theharness through the long slot of the joystick platform (37200)D. Install RNet joysticks with fixed harnesses and VR2 joysticks with 2 M-5screws in the front two holes which are 1-9/16” apart (see figure 6) to platform(37200)E. Install RNet joysticks with removable harness in the two rear holes which are1 9/16” apart (see figure 6)F. Install Q-Logic 1, 2 or 3, NE+, Shark joysticks with two M-5 screws using the2 holes which are 1-3/16” apart (refer to figures 6 & 7)G. Install LiNX joystick by installing the LiNX mounting bracket to the top of theErgoReJoy platform using the two holes shown in figure 6. Mount LiNX joystick toLiNX mounting plate. Position housing of joystick at least 1/4” from the two 1” ballson top of the ErgoReJoy joystick platform and use the 2 M5 screws to install thejoystick (see figures 8 & 9).IV. Coil the joystick cable tightly and secure it under the platform using the cableholders attached. Leave approximately 3” of cable to connect to the joystick connectionharness in the next step (refer to figure 10).!1 |
Related manuals for Active Controls ErgoReJoy
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved