Actidata actiLib Autoloader 4U Quick Start Manual

Also see for actiLib Autoloader 4U: User's and service guide

Contents

Actidata actiLib Autoloader 4U Quick Start Manual Manual pdf 18 page image

actiLib Library 4U – Quick Start GuidePage 18 of 216 Connecting the Library6.1 Connecting the SCSI and power cableINFORMATION The LTO4 tape drive is an Ultra 320 SCSI LVD device.Only cables and terminators specified for Ultra 320 usesor labeled as Multi Mode should be used.WARNING Use approves power cords!Not doing so can result in the following: not meeting individual country specific safetyrequirements; insufficient conductor amp city that could resultin overheating with potential personal injuryand/or property damage; an unapproved power cord could fractureresulting in the internal contacts being exposed,which potentially could subject the user to ashock hazard.Manufacturer disclaims all liability in the event anon-manufacturer approved power cord is used.CAUTION Failure to remove the power cables from these devicescould result in damage to the Library.To connect the SCSI and power cable to the tape Library:1. Shut down and turn off the selected server. Turn off all attached devices, such as printers andother SCSI devices. Remove the power cables from the server and all attached accessories.2. Attach one end of the SCSI cable (included in the accessory package) to one of the connectors onthe back panel of the Library (see Figure 2)

/ 21

Related manuals for Actidata actiLib Autoloader 4U