Acqiris U5310A Startup Manual

Also see for U5310A: User manual

Contents

Acqiris U5310A Startup Manual Manual pdf 15 page image

Step 4: Install the CardAcqiris U5310A Startup Guide 15U5310A Front Panel FeaturesFront Panel ConnectorsPlease note that analog Input IN 1 and IN 2 have a maximumvoltage limitation of ±1.5 Vmax while using the default 1V full scalerange (±0.5 Vmax if using 0.25V FSR).Connector Type DescriptionTRG IN MMCXfemaleExternal trigger input, 50 Ω DC terminated, ±5 V range.IN 1, 2SMAfemaleAnalog signal inputs, DC-coupled and 50 Ω terminated.The input full scale ranges are selectable:Range Maximum Input0.25 V ±0.5 Vmax1 V ±1.5 VmaxJTAG MicroUSBProvides connection to the DPU for use with the U5340A FPGA Devel-opment Kit. (Not supported)TRG OUT MMCXfemaleTrigger Out signal. User selectable from several functions.I/O 1, 2, 3 MMCXfemaleUser configurable Input / Output signal. 3.3 V CMOS andTTL compatible.CLK INMMCXfemaleExternal clock input. AC coupled and 50 Ω terminated, signal level: +5to +15 dBm. (Please refer to product user manual or datasheet for sup-ported frequency values).REF IN MMCXfemaleExternal reference clock input, AC coupled and 50 Ω terminated. It canaccept a 100 MHz signal from -3 to +3 dBm.The ADC Card can usually work with signals present at the externalreference and clock inputs (REF IN and CLK IN). However, to ensure thebest performance, or if the calibration is found to be unreliable, it isrecommended to remove such signals when working with internal clock.