Chapter 3 Software Configuration3-7. USB2.0 SOFTWARE INSTALLATION UTILITY3-7-1. Installation of Utility for Windows 98SE/ 2000/XPIntel USB 2.0 Enhanced Host Controller driver can only be used onWindows 98SE, Windows 2000 and Windows XP on Intel Desktopboards. It should be installed right after the OS installation, kindlyfollow the following steps:1. Place insert the Utility Disk into Floppy Disk Drive A/B or CDROM drive.2. Under Windows 98SE, 2000, and XP system, go to the directorywhere Utility Disc is located.3. Start the “System” wizard in control panel. (ClickStart/Settings/Control Panel).4. Select “Hardware” and click “Device Manager ” button.5. Double Click “USB Root Hub”.6. Select “Driver”.7. Click “Install” to install the driver.8. Follow the instructions on the screen to complete the installation.9. Click “Finish” after the driver installation is complete.3-8. TOUCH SCREEN DRIVER UTILITY (OPTIONAL)The type of Touch Screen driver found on our CD-ROM Driver Disc areLiyi Touch or Fuji Touch, please ask your vendor, what type of touchscreen you purchased, and select the right driver to install it.To install, kindly refer to the readme.txt file found each separate file ofthe Driver Disc. If the installation time is over 1 hour, please go to BIOS setting, under“Integrated Peripherals” item to set the “USB2.0 Controller” to disable.3-9. USB CF CARD DRIVER UTILITY (OPTIONAL)To install, kindly refer to the readme.txt file found each separate file ofthe Driver Disc.PC 5171 USER′S MANUAL Page:3-9
