6English Frequently asked questionsThe following questions are possible situations that may arise during theuse of your computer and each is followed by easy answers and solutionsto the situation.Q: I pressed the power switch but the system did not boot up.A: Check the LED located above the power switch.If the LED is not lit, no power is being applied to the system. Do any of thefollowing:• Check if the voltage selector switch located on the rear panel of thecomputer is set to the correct voltage.• Check if you plugged the power cable properly into an electricaloutlet.• If you are using a power strip or AVR, make sure that it is plugged inand turned on.If the LED is lit, check the following:• Is a non-bootable (non-system) diskette in the floppy drive? If yes,remove or replace it with a system diskette and press Ctrl + Alt + Delto restart your computer.• The operating system files may be damaged or missing. Insert thestart-up disk you created during Windows setup into the floppy driveand press Ctrl + Alt + Del to restart your computer. This willautomatically diagnose your system and make necessary fixes.However, if the diagnostic utility still reports a problem, then you mayhave to perform the recovery process to restore your system to itsoriginal default factory settings.Note: For more information about recovering your system,refers to the RCD instruction sheet.Q: Nothing appears on the screen.A: Your computer's power management function automatically blanksthe screen to save power. Just press any key to turn the display back on.If pressing a key does not work, you can restart your computer. Ifrestarting your computer does not work, contact your dealer or thetechnical support center for assistance.
