Acer Veriton 5800 Manual

Also see for Veriton 5800: User guide User guide User guide Manual Guía del usuario

Contents

Acer Veriton 5800 Manual Manual pdf 78 page image

76 Chapter 4Power-On Self-Test (POST)Each time you turn on the system, the Power-on Self Test (POST) is initiated. Several items are tested duringPOST, but is for the most part transparent to the user.The Power-On Self Test (POST) is a BIOS procedure that boots the system, initializes and diagnoses thesystem components, and controls the operation of the power-on password option. If POST discovers errors insystem operations at power-on, it displays error messages on screen, generates a check point code at port80h or even halts the system if the error is fatal.The main components on the main board that must be diagnosed and/or initialized by POST to ensure systemfunctionality are as follows:T Microprocessor with built-in numeric co-processor and cache memory subsystemT Direct Memory Access (DMA) controllerT Interrupt systemT Three programmable timersT ROM subsystemT RAM subsystemT CMOS RAM subsystem and real time clock/calendar with battery backupT Onboard parallel interface controllerT Embedded hard disk interface and one diskette drive interfaceT Keyboard and auxiliary device controllersT 1.44M floppy controllerT I/O portsT One parallel portT One PS/2-compatible mouse portT One PS/2-compatible keyboard portNOTE: When Post executes a task, it uses a series of preset numbers called check points to be latched atport 80h, indicating the stages it is currently running. This latch can be read and shown on a debug board.The following table describes the BIOS common tasks carried out by POST. Each task is denoted by anunique check point number. For other unique check point numbers that are not listed in the table, refer to thecorresponding product service guide.Post Checkpoints List: The list may vary accordingly depending on your BIOS.Checkpoint DescriptionCFh Test CMOS R/W functionalityC0h Early chipset initialization:-Disable shadow RAM-Disable L2 cache (socket 7 or below)-Program basic chipset registersC1h Detect memory-Auto-detection of DRAM size, type and ECC.-Auto-detection of L2 cache (socket 7 or below)C3h Expand compressed BIOS code to DRAMC5h Call chipset hook to copy BIOS back to E000 & F000 shadow RAM.01h Expand the Xgroup codes locating in physical address 1000:002h Reserved