64 Chapter 4Insyde MobilePro BIOS POST Beep Code and POST MessagesThe POST error message index lists the error message and their possible causes. The most likely cause islisted first.NOTE: Perform the FRU replacement or actions in the sequence shown in FRU/Action column, if the FRUreplacement does not solve the problem, put the original part back in the computer. Do not replace anon-defective FRU.This index can also help you determine the next possible FRU to be replaced when servicing a computer.If the symptom is not listed, see “Undetermined Problems” on page 70.The following lists the error messages that the BIOS displays on the screen and the error symptoms classifiedby function.NOTE: Most of the error messages occur during POST. Some of them display information about a hardwaredevice, e.g., the amount of memory installed. Others may indicate a problem with a device, such as theway it has been configured.NOTE: If the system fails after you make changes in the BIOS Setup Utility menus, reset the computer, enterSetup and install Setup defaults or correct the error.Beep Code Message Descriptionshort, short, short; short,short, long“FAULTY DMA PAGE REGISTERS” DMA page registers do not function properly.short, short, short; short,long, short“FAULTY REFRESH CIRCUIT” RAM refresh circuit does not function properly.short, short, short; short,long, long“ROM CHECKSUM INCORRECT” BIOS ROM checksum failed.short, short, short; long,short, short“CMOS RAM TEST FAILED” CMOS RAM test failed.short, short, short; long,short, long“DMA CONTROLLER FAULTY” DMA controller does not work properly.short, short, short; long, longshort“INTERRUPT CONTROLLERFAILED”The interrupt controller does not work properly.short, short, short; long,long, longN/A Keyboard controller failed to respond with theself-test command.short, short, long; short,short, shortN/A No video device found.short, short, long; short,short, longN/A No RAM installed.N/A “KEYBOARD CONTROLLERFAILURE”Keyboard controller failed during system inquiryabout connected devices.N/A “KEYBOARD FAILURE” The keyboard fails to respond or no keyboard isconnected.N/A “CMOS FAILURE - RUN SCU” CMOS data error, probably due to battery powerloss.N/A “CMOS CHECKSUM INVALID - RUNSCU”CMOS checksum error.N/A “RAM ERROR AT LOCATION xxxxxx:WROTE: xxxxREAD: xxxx”The RAM failed during memory test at the indi-cated location.N/A “PARITY ERROR AT UNKNOWNLOCATION”Parity error during memory test at unknownlocation.N/A “PARITY ERROR AT LOCATIONXXXXXX”Parity error during memory test at the indicatedlocation.