61Installing a Floppy Drive into the Converted HardDrive Bay (Backplane Installed)The slimline floppy drive conversion kit can only be installed into asystem that is using either the SATA or the SCSI backplane. You willknow if you have one of these backplanes installed if you can installeither hot-swap SATA or hot-swap SCSI drives. The conversion kit mustbe installed in the left hard drive bay.1 Observe the safety and ESD precautions at the beginning of thisbook. See “Safety Information.”2 Power down the server and unplug all peripheral devices and theAC power cable.3 Remove the chassis cover. For instructions, see “Removing theChassis Cover.”4 Remove the front bezel if it is installed. For instructions, see“Removing and Installing the Front Bezel.”5 Remove the left hot-swap hard drive carrier from the chassis.6 Remove the screws that attach the slide rails to the floppy driveconversion kit carrier.7 Slide the floppy drive into the drive carrier, rear of the drive first,with the underside of the drive facing down.8 Line up the holes in the side of the drive with the holes in thecarrier. See letter “A” in the figure below.
