41Installing and removing storagedevicesThe system supports one 3.5-inch and three 5.25-inch internal storagedevices. The system comes pre-installed with a floppy drive and aCD-ROM drive. The two empty 5.25-inch half-height bays allow you toinstall additional drives such as another CD-ROM drive or a tape drive.These would provide the system additional storage capacity.Replacing the 3.5-inch floppy drive1 Observe the ESD precautions and pre-installation proceduresdescribed on page 31.2 Disconnect the IDE and floppy drive cables from the old drive.3 Press the release bracket on both sides of the drive carrier (1)before pulling it out from the chassis (2).
