Acer AL715 Manual

Also see for AL711: User manual User guide User manual

Contents

Acer AL715 Manual Manual pdf 3 page image

Connecting the LCD Monitor and BaseWhen you open the box to take the base and put on thedesk first. Then connect the LCD Monitor and baseplease.(See fig.1-1 )Figure 1-1Viewing Angle AdjustmentThe LCD Monitor is designed to allow users to have acomfortable viewing angle. The viewing angle can beadjusted from -5°to +30°.(See fig. 1-2)Figure 1-23WarningDo not force the LCD Monitor over its maximum viewing angle settings as stated above. Attempting this will result indamaging the Monitor and Monitor stand.Detaching LCD Monitor from Its StandUnscrew screws n the swivel base support column and pulldowno the hinge to release.Figure 1-3Interface for Arm ApplicationsBefore installing to mounting device, please refer to Fig.1-3.The rear of this LCD display has four integrated 4 mm, 0.7 pitchesthreaded nuts, as well as four 5 mm access holes in the plastic coveringas illustrated in Figure 1-4. These specifications meet the VESA FlatPanel Monitor Physical Mounting Interface Standard (paragraphs2.1 and 2.1.3, version 1, dated 13 November 1997). Figure 1-4Connecting the Display1. Power off your computer.2. Connect one end of the signal cable to the LCD Monitor’s VGAport or DVI port.(For AL712/AL713)(See Fig 1-5)3. Connect the other end of the signal cable to the VGA port orDVI port on your PC.4. Make sure connection are secure. Figure 1-5Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations.A ferrite-core interface cable is included in the LCD Monitor package.This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.