Acer AL712 User Manual

Also see for AL711: User manual User guide Manual

Contents

Acer AL712 User Manual Manual pdf 3 page image

Detaching LCD Monitor from Its StandUnscrew screws n the swivel base support column and pulldowno the hinge to release.Figure 1-3Interface for Arm ApplicationsBefore installing to mounting device, please refer to Fig.1-3.The rear of this LCD display has four integrated 4 mm, 0.7 pitchesthreaded nuts, as well as four 5 mm access holes in the plastic coveringas illustrated in Figure 1-4. These specifications meet the VESA FlatPanel Monitor Physical Mounting Interface Standard (paragraphs2.1 and 2.1.3, version 1, dated 13 November 1997). Figure 1-4Connecting the Display1. Power off your computer.2. Connect one end of the signal cable to the LCD Monitor’s VGAport or DVI port.(For AL712/AL713)(See Fig 1-5)3. Connect the other end of the signal cable to the VGA port orDVI port on your PC.4. Make sure connection are secure. Figure 1-5Attention: This device must be connected to an off-the-shelf video cable in order to comply with FCC regulations.A ferrite-core interface cable is included in the LCD Monitor package.This device will not be in compliance with FCC regulations when a non-ferrite-core video cable is used.Connecting the AC Power1. Connect the power cord to the LCD Monitor.(Se Fig. 1-6)e2. Connect the power cord to an AC power source.Figure 1-6Connecting the Audio Cable(For AL712/AL716)1. Connect the audio cable to the " LINE OUT " jack on your PC'saudio card or to the front panel's “AUDIO OUT” jack of yourCD ROM drive. (See Fig. 1-7)2. Connect the other end of the audio cable to the LCD Monitor's "LINE IN " jack. Figure 1-7Setting Up the LCD Monitor1. Turn on the LCD monitor’s hard power switch, located on theback of the monitor2. Turn on the LCD Monitor's soft power switch, located on thebezel of the monitor.Figure 1-8Power Management SystemThis LCD Monitor complies with the VESA DPMS (version 1.0) Power Management guidelines. The VESA DPMS providesfour power saving modes through detecting a horizontal or vertical sync. signal.When the LCD Monitor is in power saving mode, the monitor screen will be blank and the power LED indicatorwill light yellow.3