Accusplit Eagle 1020 Operating Instructions Manual

WEARING YOUR PEDOMETERWhile gently holding the belt clip open, slide the pedometeronto your belt or the top edge of your pants or skirt. It should fitsnugly and level, above one knee.Note: The pedometer should be as vertical as possible. Walkerswith larger stomachs may find it helpful to wear the pedometerfarther back on the body, toward one hip.To avoid losing or dropping your pedometer, use the includedleash and clip to fasten the pedometer securely to your clothing.Attaching the Leash: Attach the pedometer to the leash bylooping the leash around the pedometer belt clip. Next, claspthe waist-band of your clothing with the attached clip. You canalso use a safety pin to fasten the leash to your clothing, loopthe leash through your belt or belt loop or use a badge holder.OPERATING INSTRUCTIONSACCUSPLIT, Inc. • 3090 Independence Drive, Suite 148 • Livermore, CA 94551 USA800-935-1996 • 925-290-1900 • FAX 925-290-1930 • www.ACCUSPLIT.com • support@ACCUSPLIT.comACCUSPLIT®EAGLE™ 1020Congratulations on taking the first step to wellness with your purchase of anACCUSPLIT pedometer. It’s easy to set up your new pedometer.Just follow the steps below, and start walking!RESETTING YOUR PEDOMETERMost people prefer to reset step counts daily. To reset:Press RESET button to reset to zero.REPLACING THE BATTERYWhen the display starts to dim or goes blank, it is time toreplace the battery. Your pedometer uses one Type L1142(LR43) 1.5 volt silver oxide battery. To replace:1. Using a jeweler’s screwdriver or fingernail, gently prybattery cover from case, using slot at top of cover.2. Pull the old battery gently out of its holder. Replace it witha new battery. The battery’s positive (+) terminal should beFACE UP while you put it into the pedometer.3. Slide bottom of battery cover back into place, then snaptop of cover back into place.ACCUSPLITEAGLE 1020STEPSRESETVIEWING YOUR RESULTSOnce you put on your pedometer, it will automaticallybegin to record your steps.First, loop thepedometer clipNext, loop the metalclip, then clasp clothingOr, loop abadge holder, thenput into pocket(Badge holdernot included)Or, loop a belt or belt loopNO-PROOF-OF-PURCHASE LIMITED WARRANTYSee label on back of unit for details, or checkhttp://support.ACCUSPLIT.comREGISTER NOW Please returnyour AE1020 Registration to theRepair Center address in thewarranty, and we will let youknow about future products.Email (preferred)User970-060

/ 1

Related manuals for Accusplit Eagle 1020