AccuBANKER AccuSTAND D470 Quick Start Manual

Also see for LED420: User guide User guide

AccuBANKER AccuSTAND D470 Quick Start Manual Manual pdf 1 page image

7104 NW 50 Street, Miami, FL 33166 USA • 1-888-993-2228 •www.AccuBANKER.comAccuSTANDInstallation Guide for: D470 • LED420 • LED425 • LED430 • LED440Parts neededVerticalsurface installationHorizontalsurface installation1. Metal stand (1pc)2. Holding screws (4pcs)3. Rubber feet (2pcs)4. Thumb screw * (1-2pcs)*2pcs needed for D585 model only5. Guider pole (1pc)6. Guider knob (1pc)1. In the location where the detector will beinstalled, make two point marks 85 mmfrom each other Fig. 2, hole D in a horizontalposition to install the holding screws.2. Tighten the holding screws into thesurface/wall to support the metal base.3. Proceed to set up the metal base withthe detector as described in the instructionsbelow (horizontal surface installation).1. Place the rubber feet into the two holeslabeled C in Fig. 12. Screw the Guider pole into the top of thebase in hole A indicated in Fig. 1. Tighten themounting Guider knob into the Guider pole.3. Insert the Guider pole into hole E located atthe base of the detector Fig. 3. Attach theThumb screw to secure the base of the unitas shown in Fig. 4, using threaded hole Findicated in Fig. 3.45°15°Fig. 3 Fig. 4Fig. 2BDCEEFF708544.712015050A Fig. 1

/ 2

Related manuals for AccuBANKER LED420