36Meter Memory, Setup, and Data Transfer5Data TransferTransferring Results to a ComputerWe offer a variety of software to help you transfer your results. For information on ACCU-CHEK software,contact the ACCU-CHEK Customer Care Service Center at 1-800-858-8072.You can transfer your stored results to a computer to track, identify patterns, and print.Transferring Data Directly to a Computer Using Specialized Software and an Infrared Cable1. Install the software according to the instructions.2. To transfer the results to a computer, connect the infrared cable according to the instructions.3. Run the software program and follow the instructions for data transfer. Make sure the software is readyto accept data from the meter.4. With the meter off, press and hold both and until 2 arrows on the display alternately flash.5. Locate the infrared (IR) window on the top of the meter.6. Locate the IR window on the infrared cable.7. Place the meter on a flat surface. Point the 2 IR windows toward each other. They should be 1–4 inchesapart.8. Do not move the infrared cable or meter during the data transfer.9. Follow the prompts on the software.10.The software program may shut off the meter automatically when the data transfer is complete. Shouldthis occur, follow the prompts on the computer screen.NOTE• If the data did not transfer successfully, try again. Contact the ACCU-CHEK Customer Care ServiceCenter at 1-800-858-8072 if you still have problems.• To make the most of the transfer feature, make sure the meter is set to the correct time and date.51801_07021933001.indb 36 5/7/14 8:53 AM