Menu
Accton Technology WA5001 Quick Installation Manual
                                          | |
Contents
| 
Quick Installation Guide18Authentication TypeYou may choose either the Open System or the Shared Key. (Default: Open System)If Shared Key is enabled, WEP should be enabled and at least one shared key should bedefined. But you can enable WEP, and set the authentication type as Open System.Standard WEP Setup (WEP Default: Disable)Default Shared Key – Choose the Shared Key that has the encryption string you prefer(Key 1~4 for 64-bit).Note: All wireless devices must have the same Key ID values to communicate.Advanced WEP SetupHow to set up the Unique Key WEP:1. Select a unique key (5 ~ 64)2. Enter the encryption key and select the proper key size.3. Click Write and Apply to save the encryption key.4. If you want to read an encryption key, select the unique key you want to read, then clickRead and Apply to view the encryption key.5. If you want to delete an encryption key, select the unique key you want to delete, clickDelete and Apply to delete the encryption key.Using Access Control ListSet the Access Control List (ACL) to filter out specified MAC addresses. The ACLprovides a mechanism to take certain actions based on the stations MAC address. Anyframes with a source or destination MAC address entered in this table will be filtered fromthe access point.Key Length (Manual Entry) Hex Digits per Key ID64-bit: supports 4 shared keys 10 HEX digits128-bit: supports 1 shared key 26 HEX digits152-bit: supports 1 shared key 32 HEX digits |
Related manuals for Accton Technology WA5001
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved