Accton Technology SwitcHub-2se Installation Manual

Contents

Accton Technology SwitcHub-2se Installation Manual Manual pdf 24 page image

Fast SwitcHub-2se User’s GuideSetup and Configuration 2-9Verifying Port StatusCheck each connection by viewing the port status indicators listed below. (Fora more detailed description of these indicators, refer to Chapter 3.)• Link Indicates that the port has established a valid network connection.• Transmit Indicates outgoing traffic traversing the port.• Receive Indicates incoming traffic entering the port.• Full Indicates that communications have been set to full-duplex mode.• 100 Indicates that communications have been set to a speed of 100Mbps.If the Link status indicator is not functioning properly, or you experience anyother difficulties in setting up the switch, refer to Appendix A.Verifying System OperationVerify that all attached devices have a valid connection. The switch monitorslink status for each port. If any device is properly connected to the switch andtransmitting a link beat signal, the Link indicator lights up for the correspondingport. If the Link indicator fails to light up when you connect a device to theswitch, check the following items -• Be sure the twisted-pair cable is properly attached to the connected deviceand the switch. Verify that the RJ-45 plug snaps into place when attached.• See if the twisted-pair cable is functioning properly by using it for anotherport and attached device that displays valid indications when connected tothe network.• Check the length of the twisted-pair cable to be sure it does not exceed 100meters.