TRANSMISSIVEOVERHEADPROJECTORTRANSMISSIVEOVERHEADPROJECTOROPERATING INSTRUCTIONSThank you for purchasing our Overhead Projector.Please read these instructions carefully before use.Made in U.K.20060FREQ(Hz)POWERMODELVOLTLL ATT GESERIAL N110V110V110V110V220/230V220/230V220/230V220/230V230V230V230V230V230V UK230V UK230V UK230V UK832...-110832...-220832...-230832...-240833...-110833...-220833...-230833...-240834...-110834...-220834...-230834...-240A1/22324V 250WA1/23936V 400W3.15A5 x 20mm6.3A5 x 20mm13380 x 395 x 840(mm)8Kg9KgKg3.92m2.10m1.49m3.0m 1.5m 1.0m317mm (12½”)Single/TripleElement LensDistanceImage Width831...-110831...-220831...-230831...-240SPECIFICATIONDISTANCE FROM SCREEN CHARTTROUBLESHOOTING HINTSProjector will not turnon.Fan runs but no Lampillumination.Lamp illuminates butFan does not run.Projector will not focus.Uneven lightdistributionPower Cable is disconnected.Power On/Off Button (W) is inthe “OFF” position.Platform (P) is not fully closed.Projector has overheated andthermal cut out has automaticallyshut off projector.Fuse in Socket (S) has blown.Lamp Change is not positionedcorrectly.Lamp is not seated correctly.Lamp is either defective or blown.Fan rotor/blades are obstructed.Fan motor has burned out.Fresnel is incorrectly assembled.Lamp Change is not positionedcorrectly.Head Unit (C) is misaligned.Connect Power Cable to Socket(S) and electricity supply.Press Button to the “ON” position.Close Stage so that Catches (G)engage fully.Ensure air inlets/outlets (K, Q &U)are not blocked. AllowProjector to cool and reset itself).Refer to section - Maintenance& Care - “Replacing the Fuse”Slide Lamp Change to eitherposition 1 or 2.Push lamp into lamp-holdercorrectly.Replace Lamp.Remove obstruction.Call Service Agent.Refer to section - Maintenance& Care - “Cleaning” part 7.Slide Lamp Change to eitherposition 1 or 2.Call Service Agent.PROBLEM POSSIBLE CAUSE SOLUTIONPart No.- 20421/1Part No.- 20421/1