Acclaim Lighting Dyna Drum HO User Manual

Acclaim Lighting Dyna Drum HO User Manual Manual pdf 17 page image

15CHANGING THE DISPLAY SETTINGSThis option contains four settings related directly to the user display:• Invert - allows you to invert the text on the user display so that it reads correctly whenthe fixture is mounted upside-down.• Display Warning - when set to On, a warning will appear on the display if the internaltemperature becomes too high, either due to the external environment or an internalissue. The message reads: Temperature warning - please check fixture.Note: In addition to showing a warning, the fixture will protect its emitters by automaticallyreducing output to 50% if the maximum allowable operating temperature is exceeded. If theover-temperature condition persists for more than 10 minutes, the fixture will close itself down.• Temperature Unit - allows you to change between oF and oC when displaying readingsin the Fixture Information > LED Temperature section.• Display Backlight Timeout - determines whether the user display should automaticallyblank out when it is not being used, or should remain on permanently to allow the DMXaddress to be seen at all times. When set to Off, the time-out feature will be disabled andthe display will not blank out.TO CHANGE DISPLAY SETTINGS1 Enter the user menu (see page 11).2 Use the or buttons to locate the Display Settings option and press ENTER.3 Use the or buttons to locate the required sub-option and press ENTER.4 Use the or buttons to change the sub-option setting and press ENTER.SETTING AN INTERNAL COLOR/OUTPUTThis option allows you to mix a static color (or choose a white dimming level on single colormodels) which will be displayed whenever the following two criteria are met:• The Solo Behavior option is set to Internal Color Mode (or Internal Output Mode) and,• There is no DMX input signal.Once configured, you need to activate the Solo Behavior > Internal Color/Output Mode.See page 19.TO SET AN INTERNAL COLOR/OUTPUT1 Enter the user menu (see page 11).2 Use the or buttons to locate the Internal Color Mode (or Internal Output Mode -on single color models) option and press ENTER.3 On color models, use the or buttons to locate the required color sub-option.4 Press ENTER.5 Use the or buttons to change the dimming setting and press ENTER.6 Repeat steps 3 to 5 on color models until the required overall color output is achieved.