Menu
AccessMaster 891AC Quick Manual
  |
Single Button Remote ControlModel 891AC3-Button Remote ControlModel 893ACTO ERASE ALL CODES FROM MEMORYREMOTE CONTROLSMODELS 891AC & 893ACTo prevent possible SERIOUS INJURY or DEATH from a moving gate or garage door:• ALWAYS keep remote controls out of reach of children. NEVER permit children to operate,or play with remote controls.• Activate gate or door ONLY when it can be seen clearly, is properly adjusted, and there areno obstructions to door travel.• ALWAYS keep gate or garage door in sight until completely closed. NEVER permit anyone tocross path of moving gate or door.Press and hold the buttonon the remote controlthat you wish to use.“click”“click”Release the buttonwhen the garagedoor opener lightsblink or two clicksare heard.If programming toother products,press the button asecond time toactivate the product.Locate theLearn button.Press andimmediately releasethe Learn button.The Learn LED will glowsteadily for 30 seconds.Within 30 seconds...PROGRAM USING THE GARAGE DOOR OPENERFor use with AccessMaster® Garage Door Openers that have a yellow Learn button and yellowantenna. The code between the remote control and the receiver changes with each use, randomlyaccessing over a billion new codes. Refer to your product manual for the location of the learnbutton.NOTE: Your product may look different than the products illustrated in this manual.When deactivating any unwanted remotecontrol code, all previous codes will beerased. Press and hold the Learn button on garage door openeror other product until the learn LED goes out(approximately 6 seconds). All previous codes arenow erased. Reprogram each remote control youwish to use.LED LEDPress the LEARN button again,the LED will flash once.Press the LEARN button onthe door control to enterProgramming Mode.The command LEDwill flash once. The command LEDwill flash once again.Press and hold the buttonon the remote controlthat you wish to use.“click”“click” Release the button whenthe garage door openerlights blink or two clicksare heard.If programming to otherproducts, press thebutton a second time toactivate the product.PROGRAM USING THE DOOR CONTROL |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved