Acces I/O products PCI-DIO-48H User Manual

Contents

Acces I/O products PCI-DIO-48H User Manual Manual pdf 6 page image

Chapter 1: Functional DescriptionFeatures• 48 Bits of Digital Input/Output.• Interrupt Generation on Input or under program control (Model “48H”)• Change-of-state Interrupt Software Enabled in Six 8-Input Ports.(Model “48HS”)• All 48 I/O Lines Buffered on the Board.• I/O Buffers Can Be Enabled/Disabled under Program Control• Four and Eight Bit Ports Independently Selectable for I/O.• Pull-Ups on I/O Lines.• +5V Supply Available to the User.• Compatible with Industry Standard I/O Racks like Gordos, Opto-22, Potter & Brumfield, WesternReserve Controls, etc.Applications• Automatic Test Systems.• Laboratory Automation.• Robotics• Machine Control.• Security Systems, Energy Management.• Relay Monitoring and Control.• Parallel Data Transfer to/from the PC.• Sensing Switch Closures or TTL, DTL, CMOS Logic• Driving Indicator Lights or RecordersDescriptionThese PCI bus cards provide 48 bits of parallel digital input/output capability and can be installed in seven-inch(178 mm) or longer PCI-bus slots. Each I/O line is buffered and capable of sourcing 15 mA or sinking 24 mA (64mA on request). The cards contain two type 8255 Programmable Peripheral Interface chips (PPI) to providecomputer interface to 48 lines. Each PPI provides three 8-bit ports A, B, and C. Each 8-bit port can be softwareconfigured to function either as inputs or as latched outputs. Port C can also be software configured for fourinputs and four latched outputs. Pull-ups on the cards assure that there are no erroneous outputs at power-upuntil the card is initialized by system software.The feature that distinguishes the “48HS” model from the “48H" card is that the state of all inputs can bemonitored and, if one or more bits change state, a latched interrupt request can be generated. Thus, it is notnecessary to use software to continuously poll the inputs to detect a change of state. The change-of-stateinterrupt is enabled by a software write to an interrupt-enable register. Six bits in that register control six eight-bit input ports. The change-of-state interrupt latch can be cleared by a software write.Also, Port C bit 3 at each 24-bit group can be used as an external interrupt to the computer if the IEN jumpersare installed. When Port C bit 3 goes high (edge triggering) when interrupts are enabled, an interrupt isgenerated. Interrupts from the ports are OR'ed together and OR'ed with the change-of-state interrupt. Interruptlevels are assigned by the system.Tristate I/O line buffers (74LS245) are configured automatically by hardware logic for input or output accordingto the direction assignment programmed into a control register in the related PPI. Further, if a jumper is properlyplaced on the card the tristate buffers may be enabled/disabled under program control. (See the OptionSelection section to follow.)Manual PCI-DIO-48 H/HS5Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com