Menu
Accelerated Care Plus Neuroprobe 500 Pro User Manual
                                          | |
Contents
| 
NEUROPROBE® 500 PRO USER MANUAL 13COPYRIGHT 2006 - 2017, ACCELERATED CARE PLUS CORP., ALL RIGHTS RESERVEDCONFIDENTIAL AND PROPRIETARY Press the MODIFY TIME / PARAMETER button to set the desired treatment time if you wish to changefrom the default settings of 15 minutes. Press the up or down button to increase or decrease the durationfrom a minimum of one minute to a maximum of 99 minutes. The timer will count down to zero duringtreatment.NOTE: The SLD Infrared Pads always operate for the indicated treatment time for the selected protocolwith the same output regardless of the electrotherapy protocol chosen. The SLD Infrared Pads pulse atsequential frequencies of 45.4, 62.5, 83.3, KHz at a 50% duty factor. Each frequency is active for 1 minute.The frequency sequence is repeated until the timer terminates the treatment. This sequencing is notdiscernable to the user. To stop the treatment, push the START/STOP button (3) once. When the treatment time is down to zero, the treatment current is switched off and INFRARED THERAPY isdisplayed. Turn off the unit by pressing the POWER button (1/5).IFC Therapy with Pad Electrodes Press the POWER button (1/5) to turn on the Neuroprobe® 500 Pro. The display screen will illuminate, andthe unit will be in the SELECT MODALITY/PROGRAM mode. Select the treatment modality desired and the appropriate treatment program by using the modality buttons(2) to select Sensory Motor, or Nerve Block pad programs. Press the SELECT PARAMETERS button to select any settings to be modified. Press the MODIFYTIME/PARAMETER button to adjust the desired treatment time, or other settings, if you wish to change fromthe default settings. Time is preset to 15 or 30 minutes (dependent on the protocol selected). Press the up ordown buttons to increase or decrease the duration from a minimum of one minute to a maximum of 99 minutes. Position the electrodes on the patient, connect the electrode lead wires and press the START/STOP button(3). The treatment timer will begin, and the screen will provide basic treatment parameters, and will readas follows (i.e. if Pads Nerve Block was selected):IFC FF 5.0 KHz T15A: 00 mA B: 00 mA |
Related manuals for Accelerated Care Plus 140500B
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved