Abus WIRELESS ALARM SYSTEM Operating Instructions Manual

Also see for FU9010: Installation instructions

Contents

Abus WIRELESS ALARM SYSTEM Operating Instructions Manual Manual pdf 25 page image

223.2.2 Disarming partitions1. Select the partition you want to deactivate. Do this by pressing andentering the partition number [1/2/3].2. Enter your user PIN and press . You hear the following announcement:“{System / [partition x]} disarmed”.3. Repeat these steps to deactivate further partitions.Example:To deactivate partition 3 with user PIN 1-2-3-4, press the following:3 1-2-3-4IMPORTANT:If the ACTIVE LED flashes following deactivation, check the display for activated(alarmed) zones.3.2.3 Disarming under duress / silent alarmWith the ABUS wireless alarm system, you can deactivate the system with a forcedcode. If you enter the duress PIN, your alarm system is deactivated as normal, butsimultaneously a silent alarm is triggered. This alarm is transmitted to an emergencycommand centre and must therefore never be triggered arbitrarily or accidentally. Theduress PIN is used if you are forced by someone else to deactivate the system.To use the duress PIN, just add 1 to the last digit of your user PIN (see the examples inthe following table).User PIN Duress PIN1-2-3-4 1-2-3-55-6-7-8 5-6-7-96-7-8-9 6-7-8-0IMPORTANT:Never perform a forced deactivation with the duress PIN arbitrarily or for no specialreason. Emergency command centres take this very seriously and act fast!