Abus WIRELESS ALARM SYSTEM Installation Instructions Manual

Also see for FU9010: Operating instructions

Contents

Abus WIRELESS ALARM SYSTEM Installation Instructions Manual Manual pdf 71 page image

7-717.7 77 Key-fobsUnder key-fobs, you learn how to train up to eight 4-button key-fobs with rolling code to work with the ABUS wireless alarm system.With the wireless key-fob/remote control, you can activate/deactivate the system, trigger a panic alarm, and control a switch output.The following is an overview of the menu options according to their sequence in the key-fobs menu:77 11 Allocation, page 8-6877 22 Parameters, page 8-6922 33 Communication Test, page 8-70To access the Key-fob menu:In the installer menu, press 77 or press or until you find the [7] key pad menu option. Press . You seethe following on the display:You are now in the Key-fobs menu and can access the submenus as described in the following sections.7.7.1 77 11 AllocationUnder this menu option, you train the 4-button key-fobs.To access the Allocation menu:1. Select key-fobs.2. Under key-fobs, press 11 to access the Allocation menu option. You see the following on the display:3. On the alarm system, select the number of the remote control you want to train and press .4. To train the remote control: Press 11 to go to the next remote control. Press 22 to train a new remote control or overwrite an already trained remote control. Send a training signal(within 255 seconds) from the remote control by pressing the ± (activate) button on the remote control for atleast 2 seconds. Every time you press a button, the LED of the remote control lights up. When the ABUSwireless alarm system has successfully trained the remote control, you hear a short beep as confirmation. Press 33 to delete the selected remote control. Press to select either [Y] or [N] to make your selection,and then press to confirm.5. Repeat steps 2 to 4 to train further remote controls.