Abus Terxon LX Administration Manual

Also see for Terxon LX: Installation instruction Installation instructions

Abus Terxon LX Administration Manual Manual pdf 5 page image

Administration Manual – Terxon L31.4. Exiting the user menuTo return to the normal display, press repeatedly to jump back through themenus step by step until the time and date are displayed.2. Options in the user menu2.1. Option 1: Omit ZonesYou may want to exclude some zones before activating the system. For example,one room still needs to be used while the rest of the system is activated. Thisoption allows you to select zones you want to exclude.Important: ...................................................................................................................If the system is deactivated, the settings made are deleted. This preventszones from being omitted accidentally.Important: ...................................................................................................................You can only omit zones that have been set up as omittable (see InstallationInstructions, Option 11).1. Press to open the “Omit Zones “menu.2. Press the and keys or select the zone to be isolated by enteringthe 4-digit zone number (please see “Zone Numbers“ on page 16 fordetails of numbering).3. Press to change the state of the zone (omitted means that the zonewill be omitted).4. Press to change to the next zone, or to exit the menu.2.2. Option 2: Shunting 24hr ZonesThis option allows you to isolate all 24-hour zones in specific partitions. The zonesare then permanently excluded from system monitoring. However, these zonesmust have the “Isolate” attribute (see Installation Instructions, Option 11).Important: ...................................................................................................................Zones remain shunted until you use the Reinstate 24hr option (see below).Important: ...................................................................................................................Reinstating Zones may start the exit timer, depending on the selected setting,which can be “Unshunt”, “No Exit” or “Unshunt & Exit” (see InstallationInstructions, Option 45).1. Press to select Shunt 24-hr Zns.2. Press 1 to shunt zones or 2 to reinstate shunted zones.3. Press the number keys to select the partitions you want to shunt orreinstate, and confirm with . Every displayed partition is nowshunted/reinstated. (A “*” means that the partition will not beshunted/reinstated, and “.” means that you have no access to this partition.)1=Shunt 24hr2=Reinstate 24hrShunt partitionsPtns > 1*......User Menu1: Omit Zones0002 is ArmedUser Menu2:Shunt 24hr Zns