Abus TVVR30001 User Manual

Abus TVVR30001 User Manual Manual pdf 7 page image

Quick guide7Quick guideBefore you startThe following preparatory steps must be made:1. Pay attention to the general information, safety in-formation and notes on setting up and connectingthe device (see page 8).2. Check the contents of the package for completenessand damage.3. Insert the batteries into the remote control.Installing the HDDWarningSwitch off the device and disconnect it from themains power supply.Pay attention to the required grounding of the de-vice to avoid static discharge.1. Install the HDD. Use the data and power cable sup-plied.2. Firstly, establish the connection to the motherboardusing the red data cable (small connector).3. Connect the power supply cable(large 5-pin connector).4. Check that the connections are secure.5. Close the housing.Establishing the connections1. Connect the analogue cameras with BNC connec-tions 1 to 4.2. Connect the audio connections.3. Connect the LAN connection on the device to thenetwork.4. Connect the sensors to the alarm inputs.5. Connect the monitor to the BNC or VGA connection.6. Connect the mouse to the USB port.7. Establish a connection to the mains power supply.8. Switch on the device using the POWER switch onthe rear. The DVR status display on the front of thedevice lights up.NoteCheck the ABUS homepage (www.abus-sc.com) iffor this device any firmware updates are availableand install thesePasswordWarningRemember to note the admin password.The preset password is„1 2 3 4 5“.