Important Technical DataMinimum operating pressure (Basin) 0.75 barMinimum operating pressure (Bath) 1.75 barMaximum operating pressure 5.0 bar*Maximum hot water temperature 70°C*Recommended hot water temperature 46°CNote: If these temperatures or pressures are exceeded,even for short periods, damage can result. In theseinstances a thermostatic mixing or pressure reducingvalve should be installed.For manual mixing products we recommend theinstallation of a separate TMV2 product to reduce therisk of accidental scalding.All thermostatic products should be tested and cleanedat least once a year.Hot and cold supply pressures should be as closelybalanced as possible for best results. Supply pipesshould maintain the maximum diameter untilimmediately before the fitting. The differential betweenthe hot and cold water supply temperatures should besufficient to allow correct mixing function.Manufacturers Product Reference©Abode01/2021All Abode taps are either WRAS approved ormanufactured in accordance with recognisedEuropean standards. Please ensure that yourAbode product is fitted in accordance with LocalWater Byelaws.Where hot and cold water mix within any product,then suitable non return valves should beinstalled to the hot and cold supplies to preventbackflow.Whilst assembling this product take care not toaccidentally loosen any screwed assemblies.PTFE tape can be used to ensure watertight joinson threaded connections, do not over tightenconnections or allow pipes to be twisted orfolded.The installation should be periodically checkedfor damage, if the property is left unattended for aprolonged period we recommend isolating watersupplies.Abode is a registered trademark of Abode HomeProducts Limited. All errors and omissionsexcepted.Abode Home Products Limited, Unit L, Zenith Park, Whaley Road, Barnsley, S75 1HT.Tel: 01226 283434 Fax: 01226 282434 www.abode.euAll errors and omissions excepted.AB1201AB2637