AbleNet HouseMate Quick Start Manual

AbleNet HouseMate Quick Start Manual Manual pdf 1 page image

1. Open HouseMate Home Control Appa. If this is the first time opening the app,you will be asked if you would like to enterTechnician Mode - Select OKb. If you are not asked to enter TechnicianMode, in the bottom right corner of the appyou will see a spanner wrench icon .Press the wrench icon for 5-seconds to enterTechnician Mode.i. If you see the padlock icon insteadof the spanner wrench icon, completelyclose and restart the app2. In the upper left corner of the app select Project >Setup your Devices > HouseMate Hardware > Pairyour Hardware3. In the pop-up window select Skip4. In the next pop-up window select Continue5. On the HouseMate for iOS hardware, press theHouseMate Button6. In the bottom right corner of the app, press theback arrow icon to exit Technician ModeQuick Start GuideHouseMate for iOSwww.ablenetinc.com(800) 322-0956PN 98000054 (07/16 Rev. A - FN 70500252)Step 1: Install Battery1. HouseMate for iOS ships with the internal Li-Ionbattery disconnected. Use the included HexWrench to remove the three hex screws fromthe bottom of HouseMate for iOS to access thebattery.2. Connect the battery to HouseMate for iOS.3. Once the battery is connected, use the includedmini USB wall charger to charge HouseMate foriOS. While charging the status LED on HouseMatefor iOS will illuminate orange.Step 3: Pair Hardware Step 4: Add IR DevicesHouseMate for iOS can control almost any infrared (IR)controlled device. Included in the HouseMate HomeControl app are pre-loaded IR codes for some commondevices, or you can record IR signals directly intoHouseMate for iOS. To record IR signals you will needthe device remote.Record IR Devices to HouseMate for iOS1. Open HouseMate Home Control App2. In the bottom right corner of the app, press thespanner wrench icon for 5-seconds to enterTechnician Modea. If you see the padlock icon instead of thespanner wrench icon, completely close andrestart the app3. On the main screen of the HouseMate HomeControl App you will see pre-existing cells forHouse, Intercom, TV, Music, DVD, TV2, Keypad,and Stand by. Select one that you would like toprogram.Step 2: Download App1. Download the HouseMate Home Control appfrom the App Store and install on iOS deviceHouseMate Home Controlby Brian DillonHouseMate for iOS RequiresiPhone or iPad with iOS 8.4 or newerBluetooth connectioniOS Switch Control (only for switch access)Hex Screw Locations5-Switch InputSingle orDual Switch InputRelay OutCharging Port1/4-20 Threaded Insert HouseMate ButtonHouseMate LED RingHardware OverviewPackage IncludesHouseMate for iOS HardwareUSB Charger and Charging Cable2.5mm Hex WrenchQuick Start Guide

/ 2

Related manuals for AbleNet HouseMate