Hardware Setup 2-112.3.9. Floppy Disk Drive Connector (FDC)This connector supports two standard floppy disk drives via a 34-pin 34-conductorribbon cable.Connecting the Floppy Disk Drive Cable:1. Install one end of the ribbon cable into the FDC connector. The colored edge ofthe ribbon cable should be aligned with pin-1 of FDC connector.2. Install the other end(s) of ribbon cable into the disk drive connector(s). Thecolored edge of the ribbon cable should be also aligned with pin-1 of disk driveconnector. The endmost connector should be attached to the drive designated asDrive A.User’s Manual
