Hardware Setup 2-13(9). Front Panel Audio Connection Header [FP-AUDIO1]This header provides the connection to audio connector at front panel.• To use the audio connector at front panel, remove all the jumpers on this header, and then connectto front panel by the extenson cable provided with the chassis.• To use the audio connector at rear panel, disconnect the extension cable, attach the jumpers back atpin 5-6, and pin 9-10 (default setting).Pin Pin Assignment Pin Pin Assignment1 Audio Mic. 2 Ground3 Audio Mic. Bias 4 VCC5 Speaker Out RightChannel 6 Speaker Out RightChannel Return7 X 8 NC9 Speaker Out LeftChannel 10 Speaker Out LeftChannel Return11 Ground 12 S/PDIF In13 VCC 14 S/PDIF OutUser’s Manual
