2-12 Chapter 2(11). Floppy Disk Drive ConnectorThis connector supports two standard floppy disk drives via a 34-pin 34-conductor ribbon cable.Connecting the Floppy Disk Drive Cable:1. Install one end of the ribbon cable into the FDC1 connector. The colored edge of the ribbon cableshould be aligned with pin-1 of FDC1 connector.2. Install the other end(s) of ribbon cable into the disk drive connector(s). The colored edge of theribbon cable should be also aligned with pin-1 of disk drive connector. The endmost connectorshould be attached to the drive designated as Drive A.BE7II
