15 16Steps Do ThisCheck your work.7. Caution:All the signals below must be presented. If any signals below do• NOT occur,reinsert the battery again or try inserting another fresh battery.If the problem happens again, do• NOT use the pump. Switch to an alternateinsulin delivery method and call your healthcare professional or CustomerCare.Notice thea. Power up screen will appear.Listen for one long beep and four quick beeps.b.Feel two short vibrations.c.Look for the next screen.d.If you are Then do thisSetting up the pumpfor the first timeYou will see the Set Date/Time screen.Go to Section 2.2 to Set Up Your System.Replacing the batterywithin 15 minutesafter the pumphas already beeninitializedYou will see the1. TIME/DATE screen.Notice2. Next is highlighted.Press3. Enter button to return to Home screen.Reconnect cannula to cannula housing and4.then RESTART your basal delivery from yourcompanion.2 Using the System for the First Time – Quick Setup2.1 Set Up Your SystemPurpose To program basic information into your Aviator Pump including time and date, insulin profile,and inactivity alarm, using your Aviator Companion.When Do this procedure:After you have charged the companion’s battery, and installed the pump’s battery.•Before you use your companion and pump as a system for the first time.•Materials Your companion fully charged and powered on.•Your pump with battery installed.•Your companion and pump already paired. This means that your pump is associated with•your companion and your pump and companion can only communicate with each other.Information from your healthcare professional about the type of insulin you will use with•your pump and other setting information that you will need as recorded in your Table ofSettings in Section 12 – Appendix A.Helpful InformationYou will perform this task using your companion, and the settings will automatically be set up on your pump as•well.Before entering your settings, be sure to ask your healthcare professional which type of insulin you will be using•and what is the length of its action time. Record your personalized settings in the Table of Settings in Section 12– Appendix A.When you have more experience with pumping, you can set up your companion with more optional settings in•Section 6.If you are interrupted while doing this setup, the pump will beep to let you know it is waiting for you to finish•these steps.For a detailed list of the screen settings and the order in which they appear, refer to the• Freestyle AviatorMenus in Section 12 – Appendix G.Section 1: Getting Acquainted1.4 Install Pump BatterySection 2: Using the System for the First Time – Quick Setup2.1 Set Up Your SystemDOC15736_Rev-A-Man.indd 15-16 2/9/09 11:29:34 AM