Additional Features174 41-001317-05 REV01 – 06.2013Call Waiting Tone PeriodYou can specify a specific time period (in seconds) for the call waiting tone to play at regular intervals on an active callusing the parameter “Call Waiting Tone Period”. A value of “0” is the default and plays the call waiting tone only once onthe active call. When the incoming caller hangs up, the call waiting tone stops on the existing active call.You can enable or disable this feature in the Aastra Web UI.Configuring “Call Waiting Tone Period”Use the following procedure to configure “Call Waiting Tone Period”.Aastra Web UI1. Click on Basic Settings->Preferences->General.2. In the "Call Waiting Tone Period" field, enter a time period, in seconds, that the call waiting tone will be audibleon an active call when another call comes in. Default is 0 seconds.When enabled, the call waiting tone plays at regular intervals for the amount of time set for this parameter. Forexample, if set to “30” the call waiting tone plays every 30 seconds. When set to “0”, the call waiting tone is audibleonly once on the active call.3. Click Save Settings.
