Aastra 6730i User Manual

Also see for 6730I: Administrator's guide Configuration guide Release note Installation guide Quick reference guide

Contents

Aastra 6730i User Manual Manual pdf 172 page image

166 Model 6730i IP Phone User GuideAdditional Features Incoming Call Interrupts DialingThe 6730i has a feature you can enable or disable called "Incoming Call Interrupts Dialing".This feature is disabled by default. If you are dialing out on your phone, and you receive anincoming call at the same time, the incoming call goes to an available line and the LED blinks tolet you know where the call was placed by the phone. If there is no line available to take the call,a busy signal is sent to the caller. The LCD continues to display the number you were dialing.If “Incoming Call Interrupts Dialing” is enabled, the incoming call interrupts your dialingsequence and displays to the phone’s LCD for you to answer. You have a choice to ignore theincoming call. If you choose to answer the incoming call, you can answer the call, finish the call,and then hang up. You can still go back to the original outgoing call and finish dialing out.You can enable or disable this parameter in the Aastra Web UI at the path BasicSettings->Preferences->General.Transfer/Conference Call BehaviorIf you are dialing the phone to transfer or conference a call, and your phone receives anincoming call, your dialing is never interrupted (regardless of whether the “Incoming CallInterrupts Dialing” is enabled or disabled). For Transfer and Conference, the incoming callsalways go to an available line (other than the one you are using for dialing) and the incomingcall’s line LED blinks. The LCD still displays your dialing screen.Intercom BehaviorIf “Incoming Call Interrupts Dialing” is enabled and you are dialing an outgoing Intercomcall, the enabled interrupt setting takes precedence over an enabled “Allow Barge In” setting.The incoming call interrupts your dialing on an outgoing intercom call. On an incomingintercom call, the enabled “Allow Barge In” and “Auto-Answer” occurs while you are dialing totransfer or conference the call. However, the incoming call goes to an available idle line, and theLED blinks while you are dialing the second half of the conference or transfer.If “Incoming Call Interrupts Dialing” is disabled, an incoming intercom goes to an availableidle line and the LED blinks for that line. The phone answers the call under all conditions.Notes:1. On a 6730i, you must use the down arrow key to ignore the call. To answerthe call, lift the handset or press the Speaker Key.2. If you disable this field, and the phone receives an incoming call while youare dialing an outgoing call, you can pick up the call and perform transfer orconference as required.VoIPon www.voipon.co.uk sales@voipon.co.uk Tel: +44 (0)1245 808195 Fax: +44 (0)1245 808299