Supplementary featureseud-1281/1.2 – R2.0 – 02.2012 41Call recording only starts when the connection is set up. Therefore, no ring-backtones or wait tones are recorded.Call recording is temporarily interrupted during an enquiry and an e-mail is sent withthe recording made up till then. Recording restarts automatically once the call con-nection with the enquiry call party is set up and/or once the call connection with thefirst correspondent is restored.The maximum recording time for each .wave file depends on the system configura-tion. When the preset or maximum recording time is reached, the recording stopsautomatically, the file is sent to your e-mail address and a new recording starts at thesame time. Contact your system administrator for more information.You can start or end call recording with the Foxkey or with a configurable key.Notes:• Recording calls may infringe on your national data protection provisions or bepermitted only under certain circumstances. If you intend to use this functionnotify your call party in advance.• You cannot record a conversation involving more than two call parties (enquirycall, conference). The recording is automatically stopped if you park your callparty or put him on hold.Record/Stop Recording a call:Record Foxkey or function key for , as soon as you have anincoming/outgoing call or an active call.➔Call is recorded is displayed on screen.End the recording with the Stop Foxkey.➔The recording is sent to your e-mail address.Note:The LED on the function key remains lit while the recording is in progress. TheLED starts to flash before the recording reaches its maximum preset duration.Once the maximum duration is reached (or the memory is full), the recording isstopped and the LED goes off.Call recording overview:You can find the call recording overview in your e-mail box.
