Aaron D-100 Instructions Manual

Also see for D-100: Diagram Brochure

Contents

Aaron D-100 Instructions Manual Manual pdf 1 page image

The single biggest bone of contention that customers have with speaker manufacturers iscaused when a speaker is damaged by too much power input or by amplifier distortion. This is notcovered by warranty as it is deemed to be customer abuse, often the customer feels this problemshould not arise. So in an effort to further improve our relationship with you, (our valued customer),there is something we will try to help you understand in an effort to circumvent this potentialproblem.As a manufacturer it is impossible to protect or prevent you the consumer from damagingthe speaker when one of the two following things happen:1: Using an amplifier that has too much output for the speakers capacity.2: Causing the amplifier to distort by turning up the volume too high.The first problem is easy to avoid. When you purchase an amplifier you must take noteof its` power output. This will tell you the minimum size speaker to purchase. For instance ifyou purchase a 100W speaker then the amplifier must be rated at 100W or less. By the way, it isperfectly alright to use a 400W speaker with a 10W amplifier there is no limit in that direction but asa general rule an amplifier closer to the rating of the speaker will sound a little better. If the speakeris very efficient the improvement will be less obvious.The second problem is far harder to understand and avoid. You see, even if the amplifierpower is smaller than the speaker it is still possible to damage the speaker. This is caused by whatis known as distortion. An amplifier distorts when the volume control is turned up too high forcingthe amplifier past its rated power output. So an amplifier rated at 100W can be forced to put out120W. But 20W of that power is distortion and this is what damages your speaker. The hard partis to know when your amplifier has passed its limit and is distorting. The position of your volumecontrol will not tell you, if the source output, (the source is a DVD player, CD player or Tape decketc.) is high then the amplifier may distort with the volume control at 12 o’clock but on the otherhand if the source has a low output the amplifier may not distort until 3 o’clock. The only way to tellis by listening carefully to the music quality. Don’t turn the volume control any more if the soundbecomes harsher, less tight and a bit blaring. That holds even if the volume control is less than halfway.DECORINSTRUCTIONSCongratulations on choosing a pair of “Aaron” loudspeakers. We at Aaron have gone to the upmosttrouble to ensure your continuing satisfaction for many years to come. Every individual speaker mustmeet our exacting specifications with regards to performance and craftsmanship before it is allowed toleave our factory.IT IS ABSOLUTELY VITAL YOU READTHIS NEXT SECTION!OTHERWISE IT COULD CAUSE YOU ALOT OF NEEDLESS EXPENSE