January 2014 - TD 302 Operating Manual for Pressure 4117/4117R Tide 5217/5217R, Wave & Tide 5218/5218RPage 171.5.3 Additional sensor properties for Wave and Tide Sensor 5218/5218RThe user accessible properties of the Wave and Tide sensor are the same properties as for the Pressure sensor,refer Table 1-2. Additional sensor properties are listed in Table 1–4.Table 1-4 Additional sensor properties for Wave and Tide sensor, SC = System Configuration, DS = Deployment Setting.ENUM=Enumeration, INT =Integer, BOOL=Boolean(‘yes’/’no’)Property TypeNo of elementsUseConfigurationCategoryAccess ProtectionRS232/422 applicationsAir Pressure Float 1 Nominal air pressureDS NoLocal gravity Float 1 Set the local gravitySalinity Float 1 Set the salinity at the deployment siteDistance to seafloor Float 1 Set the distance between the sensor and the seafloorInstallation Depth Float 1 Installation depth in meter relative to chosen datum, bydefault set to zero = instrument referred DS LowEnable Wave BOOL 1 Enable Wave output parametersSC LowNumber of samples ENUM 1 Set the number of samples: (256, 512, 1024, 2048)Enable Tide BOOL 1 Enable Tide output parametersTidal Average Period ENUM 1Set the averaging interval for the tide measurements (10 s, 20s, 30 s, 40 s, 50 s, 1 min, 2 min, 3 min, 4 min, 5 min, 6 min, 7min, 8 min)Enable high sample rate BOOL 1 Set the sample rate to 4 HzEnable Spectrum BOOL 1 Controls inclusion of spectrum elements in the output string.UM HighEnable Pressure Series BOOL 1 Controls inclusion of the measured hydrostatic pressure inthe output string.1.6 SpecificationsFor product specifications refer Datasheet D362 for 4117/4117R, D405 for 5217/5217R, and D407 for5218/5218R on our web site http://www.aanderaa.com or contact aanderaa.info@xyleminc.comYou will always find the latest version of our documentation on the web.