A&D UA-767PC Instruction Manual

Also see for UA-767PC: Instruction manual Instruction manual

Contents

A&D UA-767PC Instruction Manual Manual pdf 11 page image

11Data in MemoryStoring Data in MemoryThis device can automatically store up to 280 sets of measurement data in itsmemory. If an error message appears, the measurement data will not be stored.Whether the data will be stored or not after the measurement can be selected asfollows:When the START button is pressed or the automatic power OFF functionworks after a measurement, the measurement data will be stored in memory.When the clock button is pressed after a measurement, the measurementdata will not be stored in memory.Recalling Memory Data1. To access measurements stored in memory, wait until the monitor is instandby mode.2. Press and hold the START button until the display shows the most recentmeasurement.3. The display will show all of the stored measurements starting with the mostrecent and then will return to standby mode.To interrupt memory display, press the START button to initiate inflation mode.To put the monitor in standby mode, press the START button again.Erasing Data in Memory1. To erase measurements stored in memory, wait until the monitor is in standbymode.2. Press and hold the clock button until the buzzer sounds and the memoryaccess indicator blinks. All data in memory will be erased.