A&D HW-10KGL Instruction Manual

Also see for HW-100KGL: Instruction manual Instruction manual Instruction manual

Contents

A&D HW-10KGL Instruction Manual Manual pdf 11 page image

HW-G Instruction Manual Page 9 HW-G OZIM v1a5 Installing the ScaleThis procedure includes all of the steps for installing the HW-G series scalesStep 1 UnpackingRemove the weighing pan from the carton andplace to one side. Remove the base unit andcolumn from the carton, taking care not to pullon the loadcell cable.Step 2 Secure the ColumnStep 2a Remove the 4 Allen screws fromthe column lower bracket.Step 2b Pull the excess loadcell cablethrough the column as you position the col-umn to the base unit, so as not to damagethe loadcell cable. Affix the column to thebase unit using four 5mm Allen screws.Stpe 3 Secure the Display UnitStep 3a Remove the 2 screws from the rearof the display unit, position the display unitonto the column bracket and pull the excesscable back down the centre of the column tothe base unit. Ensure that the cable exits viathe cut out in the display unit column bracketand secure the headwork with the 2 screws.Step 3b Carefully make the connectionbetween the cable connector and J1 insidethe headwork, then secure the rear displaypanel.Step 4 Fit the PanStep 4 Fold the excess cable at thebasework end and secure with the ‘twist andtie’ strip provided.Fit the pan to the base unit.* )00 !0)#!"0.0!(1)"0,