A&D AD-8922A Instruction Manual

Also see for AD-8922A: Instruction manual

A&D AD-8922A Instruction Manual Manual pdf 7 page image

5２-１ Displayz Displays the weighing data and the unit (or mode) received. The unit (or mode) may be different fromthat of the weighing instrument.z Turns on the stabilization indicator when the header of the weighing data received is "ST", "QT", or "WT".z Turns on the comparator indicator when the comparison results are added to the data received.Applicable to GX-K, GF-K, GP and AD-4212A/B. (Function setting "Cp-r")z When nothing has been received for two seconds or more, the bar display [- - - - -] appears. Bychanging the function setting, the previous data received is displayed until the next data is received(Hold display). During the hold display, the hold indicator is turned on.Note: When the data is in eight digits, the highest-order digit is displayed in the upper leftcorner as shown below.For example, if the weighing data is 101.00000 g, the display is like .２-２ Key OperationAvailable key operations to control the weighing instrument depend on the weighing instrument used. Fordetails, see Table 2 in " 1-2 Applicable Instruments".Set the command set "C5et" of the function setting, appropriate to the weighing instrument.To enter the function setting mode of the AD-8922A, press and hold the ON:OFF key and press the CALkey.The weighing instrument has its own function settings and the AD-8922A can not change those settings.２-３ Connectors２-３-１Connector to the weighing instrument (BALANCE / SCALE) ... D-Sub 9-pin maleUsed to connect to the weighing instrument. The cable used for connection depends on the instrument.For details, refer to the instruction manual of the weighing instrument.２-３-２Connector to the external device (PC / PRINTER) ... DIN 8-pin femaleUsed to connect to an external device such as a personal computer or a printer (AD-8121B). The cableused for connection depends on the device. For details, refer to the instruction manual of the device.