Aaeon BOXER-8220AI User Manual

Aaeon BOXER-8220AI User Manual Manual pdf 19 page image

Chapter 2 – Hardware Information 8Compact Fanless Embedded AI@Edge Box PC BOXER-8220AI2.3 List of JumpersThe board has a number of jumpers that allow you to configure your system to suityour application.The table below shows the function of each of the board's jumpersLabel FunctionCN14 (Pin 7-8) AT/ATX mode select2.3.1 Setting JumpersYou can configure your system to match the needs of your application by settingjumpers. A jumper is the simplest kind of electric switch. It consists of two metal pinsand a small metal clip (often protected by a plastic cover) that slides over the pins toconnect them. To “close” a jumper you connect the pins with the clip.To “open” a jumper you remove the clip. Sometimes a jumper will have three pins,labeled 1, 2 and 3. In this case you would connect either pins 1 and 2 or 2 and 3.1 2 3Open Closed Closed 2-3A pair of needle-nose pliers may be helpful when working with jumpers.If you have any questions about the best hardware configuration for your application,contact your local distributor or sales representative before you make any changes.Generally, you simply need a standard cable to make most connections.