AGA DC6 User Manual

Also see for Six-Four Series: Owner's manual Owner's manual

AGA DC6 User Manual Manual pdf 8 page image

ELECTRICAL CONNECTION IS LOCATED AT THE TOP RIGHT HAND SIDE OF THEAPPLIANCE, BEHIND SIDE PANEL. DURING INSTALLATION REMOVE THE RIGHT HANDSIDE PANEL TO CONNECT ELECTRICAL SUPPLY.Remove 6 screws securing side panel to gain access to mains terminal. See Fig. 3 for locationof cover.Remember that the mains electrical cable must be routed through the grommet at the rear righthand side of the cooker near the top via a UL listed strain relief bracket, before connecting to themains terminal connection.REFER TO FIG. 2 & 2A for wire connection to appliance.Remember that an excess of cable length is required inside the cooker to allow for possibleservicing of the spark generator, there should be at least 1.22m of cable from the appliance.Remember that an excess of cable length is required behind the cooker for the withdrawal of thecooker from between the kitchen units etc.Replace the right hand side panel once electrical connection has been made and replace fixingscrews.NOTE: Ensure the insulation card covering the mains terminal is in place, between the sidepanel and mains terminal.ELECTRICAL CONNECTION (continued)Fig. 2Fig. 2ADESN 512637DESN 5129518