g9Preparing for use3 Before using for the first time, it isadvisable for reasons or hygiene toclean the mixing attachment.Dry the mixing attachment well beforeusing it.Inserting/removing the mixingattachment (Figure 3)1 Before inserting or releasing the mix-ing attachment, switch off the blenderand remove the plug from the mainssocket!0 Insert the mixing attachment to themotor part and lock it by turningclockwise.0 Tor remove, unlock the mixing attach-ment by turning it anticlockwise.Working with the blender1 The appliance can be used for up to1 minute without stopping. It shouldbe allowed to cool afterwards for atleast 1 minute.0 Insert the blender deep into the bowl,then press switch A (for speed I) orswitch B (for speed II) (Figure 3).3 Start all types of processing at speed I.This will avoid powdery foods and liq-uids spraying out.Light upward and downward move-ments of the blender permit the mate-rial being worked on to be handled inthe best possible way. Please make surethat:– the mixing attachment never hasmore than two-thirds of its lengthimmersed in the material,– the mixing bowl is never more thantwo-thirds full (to avoid the dangerof splashes).Cleaning and care1 Remove the plug from the mainssocket before cleaning.Ensure that no water penetrates intothe inside of the appliance! Neverclean the motor part under runningwater and never immerse in water.0 Wipe the motor part with a dampcloth.0 Clean the mixing attachment aftereach use by holding it in a bowl withhot water, possibly adding some com-mercially available washing-up liquid,and allow the appliance to run forserveral seconds.1 The mixing attachment is not to bewashed in a dishwasher!Technical dataMains voltage: 230 VPower consumption: 400 WMaximum continuousoperating time: 1 minute; This appliance complies with the fol-lowing EC directives:• 73/23/EEC of 19/2/1973 "Low volt-age directive", including the modifi-cation directive 93/68/EEC.• 89/336/EEC of 3/5/1989 "EMC direc-tive", including the modificationdirective 92/31/EEC.