AEG OEKOS2942-1KG Instruction Booklet

AEG OEKOS2942-1KG Instruction Booklet Manual pdf 8 page image

34Levelling the appliancer To move the appliance to the required position, simply push lightly against the top door totilt the appliance backwards. Its weight is therefore transferred to the rear castors to alloweasy movement.r Place the appliance on a flat hard floor. The two adjustable feet on the front of the appli-ance enable it to be accurately levelled by screwing them in or out as required (Fig. 2).Electrical connectionWARNING: THIS APPLIANCE MUST BE EARTHED.Please ensure that the voltage and current indicated on the rating plate agree with thevoltage of your electricity supply.220/240 volts (i.e. 220/240 V AC).If your appliance has been equipped with a mains lead with a moulded-on type plug, youmust comply with the following regulations: The plug moulded onto the cord incorporatesa fuse. For replacement, use a 13 amp BS 1362 fuse. Only ASTA approved or certifiedfuses should be used. The fuse cover/carrier must be replaced in the event of changingthe fuse. The plug must not be used if the fuse cover/carrier is lost. A replacement cov-er/carrier must be obtained from an electrical goods retailer. If the socket outlets in yourhome are not suitable for the plug fitted to the appliance, then the plug must be cut offand an appropriate one fitted. When fitting the plug please note the following points:ImportantThe wires in the mains lead are coloured in accordance with the following code:Green and Yellow - Earth Blue - Neutral Brown - LiveAs the colours of the wires in the main lead of this appliance may not correspond with thecoloured markings identifying the terminals in your plug, proceed as follows:1. The wire which is coloured green and yellow must be connected to the earth terminalin your plug, which is marked with the letter E or by the earth symbol or colouredgreen, or green and yellow.Fig. 2Installation