Indicator lightsSalt Illuminates when the special salt has run out. 1)Rinse aid Illuminates when the rinse aid has run out. 1)End of programme Illuminates when the washing programme hasended.1) The salt and rinse aid indicator lights are never illuminated while a washing programme is running even if fillingwith salt and/or rinse aid is necessary.The digital display indicates:• the level of hardness to which the water softener is set,• the number corresponding to the washing programme,• the approximate remaining time of the running programme,• activation/deactivation of the rinse aid dispenser ( ONLY with Multitab function active),• the end of a washing programme (a zero will appear in the digital display),• the countdown of the delay start,• fault codes concerning malfunction of the dishwasher,• activation/deactivation of the audible signals.NIGHT CYCLE buttonNight Cycle is a silent washing programme that will not disturb you, even when you sleep.It can be set at night or in times with a more economical power rate.During the Night Cycle the pump runs at a very low speed to reach a noise level reductionof 25% compared to the declaration programme. As a consequence, it has a very longrunning time.Half load buttonThis option is useful and economical when baskets are not fully loaded. It reduces theconsumption of water and energy.Remember to load both baskets.When using this option we recommend to reduce the dose of detergent that is normallyused for a completed load.This option is available only with some programmes (see "Washing programmes" chart).Function buttonsThe following functions can be set with the help of these buttons:• setting of the water softener,• cancel a washing programme or a delay start in progress,• activation/deactivation of the rinse aid dispenser when Multitab function is active,• activation/deactivation of the audible signals.6 Control panel