AEG Electrolux 925033685 User Manual

Contents

AEG Electrolux 925033685 User Manual Manual pdf 6 page image

8 Freezer compartment indicator9 FROSTMATIC indicator10 FROSTMATIC button11 Freezer temperature regulator, + button12 Freezer temperature indicator13 Freezer temperature regulator, - button14 Alarm reset button15 Alarm indicatorSwitching on1. Insert the plug into the mains socket.2. Set ON/OFF switch to ON.3. The alarm indicator light flashes since the temperature is reached.The acoustic alarm sounds.4. Press the alarm reset button to reset the alarm.Switching offTo switch the entire appliance off:1. Set ON/OFF switch to OFF.2. Disconnect the mains plug from the mains socket.Temperature indicatorsThe temperature indicators show several information:• During normal operation, the temperature currently present in the fridge (ACTUAL tem-perature) is displayed.• In the freezer the warmest temperature is displayed (ACTUAL temperature). When fullyfilled, the warmest zone is normally located at the top in the front area of the freezer.Depending upon how the section is filled, the temperatures are lower in other areas ofthe freezer.• When the temperature is being adjusted a flashing display indicates the fridge temper-ature currently set (DESIRED temperature).When changing the temperature setting wait about 24 hours until the temperature displayhas stabilised.If there is a fault in the appliance the temperature indicator shows:• a square or a letter in the temperature indicator of the fridge for a fault in the fridge• a square or a letter in the temperature indicator of the freezer for a fault in the freezer.Temperature regulationTo operate the appliance, proceed as follows:1. Set the required temperature by pressing the corresponding temperature regulator. Thetemperature indicator will immediately show the changed setting (DESIRED tempera-ture) and the temperature indicator flashes.2. Each time the temperature regulator is pressed the DESIRED temperature is adjustedby 1 °C. The DESIRED temperature must be reached within 24 hours.3. Once the required temperature has been set, after a short period (approx. 5 sec.) thetemperature indicator will show again the current ACTUAL temperature inside the cor-6 Control panel