Remove anyobjects from thepump impeller byrotating it.Put the cap backon the emergencyemptying hose andplace the latterback in its seat.Screw the pump fully in.Close the pump door.Water inlet filterIf you notice that the machine is taking longer to fill, check that thefilter in the water inlet hose is not blocked.Turn off the water tap.Unscrew the hose from the tap.Clean the filter in the hose with a stiff brush.Screw the hose back onto the tap.Emergency emptying outIf the water is not discharged, proceed as follows to empty out themachine:• pull out the plug from the power socket;• close the water tap;• if necessary, wait until the water has cooled down;• open the pump door;• place a bowl on the floor and place the end of the emergencyemptying hose into the bowl. Remove its cap. The water should drainby gravity into the bowl. When the bowl is full, put the cap back onthe hose. Empty the bowl. Repeat the procedure until water stopsflowing out;• clean the pump if necessary as previously described;• replace the emergency emptying hose in its seat after having plug-ged it;• screw the pump again and close the door.37Cleaning and maintenance