AEG BE7614000 User Manual

AEG BE7614000 User Manual Manual pdf 11 page image

Residual heat indicatorDisplay shows the residual heat indicator (residual heat symbol) after end of every cookingsessions when the temperature inside oven cavity is more then 40°C. Display also shows theoven temperature.BEFORE FIRST USEWARNING!Refer to "Safety information" chapter.Initial Cleaning• Remove all parts from the appliance.• Clean the appliance before first use.Refer to chapter "Care and Cleaning".First connection to the mainsAfter first connection to the mains all symbols in the display are on for some seconds. Forthe subsequent few seconds the display shows software version.First setting the time of dayAfter the software version goes off, the display shows "h" and "12:00".Setting the time of day:1. Touch or to set hours.2. Touch or .3. Touch or to set minutes.4. Touch or .The Temperature/Time display shows new time.Changing the time of dayYou can change the time of day only if the appliance is off.Touch . flashes in the display. To set new time of day use the above procedure.Pre-heating1. Set function and maximum temperature.2. Let the appliance operate without the food for approximately 1 hour.3. Set function and maximum temperature.4. Let the appliance operate without the food for approximately 10 minutes.5. Set function and maximum temperature.6. Let the appliance operate without the food for approximately 10 minutes.This is to burn off the residue in the appliance. The accessories can become more hot thanusually. When you pre-heat the appliance for the first time, the appliance can make anodour and smoke. This is the usual effect. Make sure the airflow is sufficient.Before first use 11