If you press button during setting hours for DURATION , the appliance goes to settingof the END function.When END function is activated the Timer/Residual heat indicator shows relation betweenTime of day and END time set.Setting the MINUTE MINDERUse to set a countdown (maximum 23:59 minutes) This function has no effect on theoperation of the ovenSet the function when the appliance is off:1. Press .and " 00 " flash in the display.2. Press or to set the seconds.3. Use the same procedure to set minutes and hours.When you set hours, minutes replaced seconds on the display and hours replaced mi-nutes. Symbol comes on the display.4. MINUTE MINDER starts to operate automatically after 5 seconds.After 90% of set cooking time an acoustic signal sounds.5. When set time ends, an acoustic signal sounds for 2 minutes and " 00:00 " and flashin the display.You can set the MINUTE MINDER any time, even if the oven is off.If you set the MINUTE MINDER when DURATION or END is running, the symbol goes onthe display. The Timer/Residual heat symbol shows relation between set and current DU-RATION (or END) time.CounterUse the Counter to monitor how long the oven operates. It is on immediately when theoven starts to heat.Reset the Counter: press again and again to see the Counter function. Press and holdand then the Counter start to count up again.You can not use Counter when Duration or End is set.USING THE ACCESORIESWARNING!Refer to "Safety information" chapter.Core temperature sensorCore temperature sensor measures the core temperature of the meat. When the meat is atthe set temperature, the appliance deactivates.Using the Accesories 11