WHAT TO DO IF…During operation of the appliance some smaller but annoying trouble can often occur,which does not require calling a technician out. In the following chart information is givenabout them to avoid unnecessary charges on service.The operation of the appliance goes with certain sounds (compressor and circulatingsound). This not means a trouble, but a normal operation.The appliance operates discontinuously, so the stopping of compressor does not mean being no current. That is why you must not touch the electrical parts of the appliance beforebreaking the circuit.Problem Possible cause SolutionThe appliance is noisy. The appliance is not supportedproperly.Check if the appliance stands stable (all feet and wheels should beon the floor). Refer to "Levelling".The buzzer sounds. TheAlarm icon flashing.The temperature in the freezer istoo high.Refer to "HighTemperatureAlarm".The door is not closed correctly. Refer to "Door open alarm".upper or lower squareis shown in the temperature display.An error has occurred in measuring the temperature.Call your service representative(the cooling system will continueto keep food products cold, buttemperature adjustment will notbe possible).“dEMo” appears on thedisplay.The appliance is in demonstration mode.Keep pressed approximately 10sec the OK button since a longsound of buzzer is heard and thedisplay shut off for a short while:appliance start works regularly.The compressor runs continuously.The Temperature regulator maybe set incorrectly.Set a warmer temperature.The door is not closed correctly. Refer to "Closing the door".The door has been opened toofrequently.Do not keep the door open longerthan necessary.The food temperature is toohigh.Let the food temperature decrease to room temperature before storage.The room temperature is toohigh.Decrease the room temperature.There is too much frostand ice.The door is not closed correctly. Refer to "Closing the door".The door gasket is deformed ordirty.Refer to "Closing the door".What to do if… 33